CompuLab SBC-FITPC2 Uživatelský manuál stáhnout pdf (Strana 19)

4.10. LED’s and Push Buttons

SBC-FitPC2 push buttons

• The SBC-FitPC2 features two user-accessible push buttons:

• SW1 is the main system hardware reset button.

• SW2 is the main system power on / off / suspend button.

SBC-FitPC2 LED’s

The following table describes SBC-FitPC2 LED’s:

LED Designation LED activity

DS1 HDD access ON when HDD is accessed

DS2 WiFi Activity Depends on a mini PCI-express

WLAN module. Refer to the WLAN

module datasheet.

DS3 System power ON when the system is in active

state, OFF in suspend-to-RAM and

off states.

4.11. Consumer Infrared Receiver

The SBC-FitPC2 features a Consumer Infrared receiver, based on a programmed micro

controller with USB interface.

4.12. Extension connector for RST, GPIO, I2C, LPC bus (P16)

SBC-FitPC2 provides the ability to connect external devices using extension interface. 40-

pin 0.5mm pitch FPC connector is used.

Pin Name Pin Name

1 +5V_STBY 21 +3.3V_STBY

2 +5V_STBY 22 RESERVED

3 +5V_STBY 23 RESERVED

4 +5V_STBY 24 GND

1 2 ... 14 15 16 17 18 19 20 21

Žádné komentáře

CompuLab SBC-FITPC2 Uživatelský manuál Strana 19